Important!

The rails on the 3.5-inch drive are different from those on the CD-ROM drive. Make sure you install the correct rails on each drive.

6.Remove the rails on both sides of the drive, and snap them onto the new drive in the same positions. Make sure the front rail extensions are towards the front of the drive.

7.Align the rails with the appropriate bay, and slide the drive into the bay until the locking tabs snap into place.

8.Connect the power and data cables, making sure the cables match their original position. (See drive documentation for proper drive jumper settings and cable orientation.)

9.Close the case, as described in Chapter 1.10.Reconnect the power cord and turn on the system.

Installing an additional 3.5-inch device

The second 3.5-inch drive bay can be used to install a 3.5-inch device, such as a tape drive or 100MB or 120MB disk storage device. A set of rails are included with your system and are used during the installation. You will have to purchase an IDE cable with three connectors and of sufficient length to connect the existing hard drive and the new drive to the riser card IDE connector.

30 Maintaining and Troubleshooting Your E-3200 System