Adding a second hard drive

The system comes with a metal drive mounting plate you can use to install an additional internal hard drive. You will have to purchase an IDE cable with three connectors and of sufficient length to connect the existing hard drive and the new drive to the riser card IDE connector.

To install a second hard drive

1.Turn off the system and disconnect the power cord.

2.Open the case, observing the “Static Electricity Precautions” on page 2.

3.Locate and remove the two screws that attach the mounting plate to the front of the chassis.

4.Remove the CD-ROM drive from the chassis so you can access the slide plate (see “Replacing the 3.5-inch diskette or CD-ROM drive” on page 29).

5.Slide plate towards the back of the chassis until the tabs disengage from the chassis. Lift the mounting bracket out of the chassis.

System Components 33