3.5-inch hard drive

5.25-inch CD

drive

 

3.5-inch diskette drive

Additional 3.5-inch

Additional 3.5-inch

hard drive bay

drive bay

As you prepare to install drives, keep the following in mind:

■To remove and install drives, you need a grounding wrist strap and a Phillips screwdriver. If you remove a drive, place it in an antistatic bag.

■Before you install a drive, see the drive’s documentation for information on configuring the drive, setting any jumpers on the drive, and attaching cables to the drive.

■If you are installing a drive that uses an add-in controller, install the add-in card before you install the drive.

■IDE hard drives can be configured as single, master, or slave. IDE CD drives can be configured as master or slave. Configure the drives by using the drive-select jumpers located on the drives.

22Replacing and Adding Drives