5Remove the metal shield from the front of the drive bay, if installed, by placing a flat-bladed screwdriver in the metal shield tab and pulling it outwards.

Caution Your system was designed to adhere to electromagnetic interference requirements and the shield is an integral part of the system. Installing an approved device should continue to maintain those standards. If you remove the device you should reinstall the shield.

6Snap the rails onto the drive, making sure the front rail extensions are towards the front of the device.

7Align the rails with the bay, and slide the drive into the chassis until the locking tabs snap into place.

8Connect the power and data cables to the back of the drive. (See drive documentation for proper drive jumper settings and cable orientation.)

9Reinstall the CD drive and 3.5-inch diskette drive (see “3.5-inch diskette or CD drives” on page 24 for instructions.)

10Close the case (see “Closing the case” on page 19.)

11Reconnect the power and modem cords, then turn on the system.

12Run the configuration software, if required.

3.5-inch diskette or CD drives

27