5Locate an available slot and remove the slot cover by releasing the lock tab. Save the cover for reinstallation if you need to remove the card. (You can use a blunt tool such as a flat-bladed screwdriver if the tab does not release with finger pressure.) Either apply inward pressure to the middle of the slot cover or use a flat-bladed screwdriver and insert it into the tab hole.

6Insert the edge of the expansion card into the slot on the riser card and press firmly to seat the card.

7After seating the card firmly, replace the slot cover bracket.

8Connect any cables to the card (see card documentation for proper jumper settings and cable orientation)

9Close the case (see “Closing the case” on page 19.)

10Reconnect peripherals, the modem cord, and the power cord, and turn on the system.

You may need to reconfigure your system after installing some expansion cards. You may also need to install software that came with the card. Check the card documentation for additional information.

Adding an expansion card

43