The diskette drive will not read, write, or format

 

Probable Cause

Solution

 

 

 

 

The diskette is not IBM

Make sure the diskette you are trying to format

 

formatted.

is IBM compatible. If it is, try reformatting it.

 

 

 

 

The diskette is

Run ScanDisk on the diskette. If errors are

 

corrupted.

detected and corrected, try accessing the

 

 

diskette again.

 

 

 

 

The disk is write

Make sure the write-protection window on the

 

protected.

upper-right corner of the diskette is closed

 

 

(unprotected.)

 

 

 

The diskette drive LED illuminates continuously

 

Probable Cause

Solution

 

 

 

 

The diskette is

Remove the diskette from the drive. If the light

 

corrupted.

remains on, try restarting the system.

 

 

 

 

The cable to the drive is

Open the system, then check the cable

 

not connected properly.

between the diskette drive and its controller.

 

 

Make sure the pins are not bent or misaligned.

 

 

 

An adapter card is not recognized by the system

Probable Cause

Solution

 

 

The interrupt and/or I/O

Check the address configuration of the adapter

address is set

card and make sure that it does not conflict

incorrectly.

with another card in the system.

 

 

The card has not been

Configure the card with the appropriate

configured through the

software.

software.

 

 

 

The card was not

Reseat the card, then make sure that its

installed correctly.

jumpers are configured appropriately.

 

 

Peripheral/adapter problems

79