GBC H800 PRO-R manual Features Guide Cont’D

	C
	F
E	D

Figure 3

H

G

O

Figure 3A

J

K

Figure 4

L M

Figure 5

FEATURES GUIDE (CONT’D)

C. SAFETY SHIELD: (Figure 3.) Prevents inadvertent contact with the heat shoes.

D. FEED TABLE: (Figure 3.) The Feed Table is used to position

items for lamination. The laminator will operate only when the Feed Table and Feed Table Latch are properly installed.

E. FEED TABLE LATCH: (Figure 3.) Used to lock the Feed Table into position and activate an interlock switch. The latch is located on the left underside of the Feed Table. The table cannot be removed without retracting the latch to the right while lifting

the table upwards and away from the laminator. The laminator will not operate when the table is removed and/or the latch is retracted.

F. FEED GUIDE: (Figure 3.) The Feed Guide aligns the item(s) to be laminated and is used to keep longer items straight. The Feed Guide may also be used to feed smaller items side by side by positioning the guide towards the center of the Feed Table and placing smaller items against each side of the Feed Guide as they are being introduced into the nip point of the heat rollers. To position the adjustable guide, loosen the knob on the top of the guide, slide it to the desired position and tighten the knob to secure in place.

G. HEAT SHOES: Teflon coated heat shoes melt the adhesive on the laminating film before it is compressed by the nip rollers. (Figure 3A).

H. IDLER BAR: The idler bars, located near each supply roll are, used to direct the film to the heat shoes.The bottom Idler Bar is movable to ease film loading.

I. PULL ROLLERS: The pull rollers, located at the back of the laminator, are motor driven. They simultaneously pull the film and improve the quality of the laminated item.

J. REAR SLITTER: Used to cut the film web where it exits the rear of the laminator (Figure 4).

K. CIRCUIT BREAKER: Electrical safety device, located under the left side cover, can be reset by the operator if tripped. (Figure 4).

WARNING: If the breaker trips a second time after being reset,

!￿contact GBC national Service or your dealer/distributor for assistance.

L. FILM SHAFT: The film shaft holds the supply roll and the adapters with locking collars hold the rolls of film on the shaft, (Figure 5).

M. CORE ADAPTERS: Align the film on the film shaft , (Figure 5) for various widths of roll film

N. FILM WEB: The part of the loaded film that is visible between the supply roll and heat shoe.

O. NIP ROLLERS: Located behind the heat shoes. The nip point is where the heated film is compressed and pulled through the laminator.

P. AUTO SHUT-OFF:After two hours of laminator inactivity the heaters will automatically shut down. To re-set, push the power switch located at the rear of the machine to the OFF position marked “O” and then back to the ON position marked “I”. Wait until the “ready light” illuminates and resume lamination.

6