Installation

ORCA-IV Image Transfer Laminator Operation Manual

 

 

8QSDFNLQJ

☞NOTE

ALL SHIPMENTS ARE EX- WORKS. At our dock title passes to the buyer Please review your insurance coverage prior to shipment, as you are responsible for all subsequent freight charges and risks. Before signing the Bill of Lading you should be sure to inspect the machine for signs of damage or missing items; if appli- cable, you should make a note of this on the Bill of Lad- ing.

The ORCA-IV Image Transfer Laminator is shipped encased in shrink wrap via Air Ride Van.

To unpack the machine:

7.Have the image transfer laminator rolled off the Air Ride Van and placed on the floor by licensed riggers.

IMPORTANT

Do not attempt to move the image transfer laminator across anything other than a flat, level surface without trained and qualified riggers. You can be crushed or seriously injured.

The ORCA-IV Image Transfer Laminator is a

large and heavy piece of equipment. It is necessary to employ LICENSED RIGGERS ONLY to move the machine. The image transfer laminator is not designed to be tipped up or sideways in any way. Such action disturbs the exact alignment of the rolling parts of the machine and requires extensive realignment. GBC Pro-Tech’s warranty does not cover malfunction of the equipment due to mishandling and/or tipping.

GBC Pro-Tech bears no responsibility for personal injury or damage due to moving the image transfer laminator improperly.

8.Gently unwrap the shrink wrap from around the image transfer laminator and remove the foam pro- tecting the corners of the machine.

IMPORTANT

Do not use a knife or other sharp instrument during installation or while servicing the image transfer laminator. You can cause irreparable damage to the rolls.

9.Carefully remove any accessories packed with the machine. The accessory pack should contain:

1 Towel, white

1 Slitting knife

1 Set, hex wrenches

4 Leveling pads

3 Fuses (6A, 250V)

1 Tape measure

1 Rubber cement pick-up

1 Strain relief

1 Manual

4 Slitter Assemblies

2 T-handle wrenches (1/4")

2 Web unwind spacers

10.Remove any plastic strapping and packing paper taped to the rolls.

IMPORTANT

Do not use a knife or other sharp instrument during installation or while servicing the image transfer laminator. You can cause irreparable damage to the rolls.

11.Remove all packing materials to a safe distance from the image transfer laminator.

12.Level the machine using the procedure included in this section.

2-4

© GBC Pro-Tech 1998 October