Operation

ORCA-IV Image Transfer Laminator Operation Manual

 

 

3URFHGXUH

1.See process chart 3-1 and diagram 3-1a for mate- rial mounting instructions and machine adjust- ments.

2.Web the vinyl up around the bottom main roll and over to the pull roll. Make sure the material is webbed straight and lower the pull roll to hold the vinyl.

3.Web the paper through as shown in diagram 3-1a.

Often, when paper is not on a core, hand tension must be applied to the paper in order to maintain transfer quality until the end of the transferred image.

0DFKLQH￿6KXWGRZQ

It is very important that the ORCA-IV Image Transfer Laminator is shut down in proper manner. If not, the rolls can be damaged or destroyed.

IMPORTANT

Failure to follow this procedure can result in

damage to the rolls.

3URFHGXUH

1.Raise the upper main roll and upper pull roll so that the rolls do not make contact with the bottom rolls.

2.Turn off the main power to the machine.

3.Disconnect the air supply to the machine if the machine is not to be used for the next several days.

IMPORTANT

The main and pull rolls must always be in the up position when the machine is not in use.

3-16

© GBC Pro-Tech 1998 October