Safety | |
|
|
IMPORTANT
Do not operate the image transfer laminator near water. You can be severely shocked, electrocuted or cause a fire.
DANGER
Remove and lockout power from the image transfer laminator before servicing. You can be severely shocked, electrocuted or cause a fire.
IMPORTANT
Do not use liquid or aerosol cleaners on the image transfer laminator. Do not spill liquid of any kind on the image transfer laminator. You can be severely shocked, electrocuted or cause a fire. Use only a damp cloth for cleaning.
IMPORTANT
Use only 80% (or stronger) isopropyl alcohol or a rubber cement eraser to clean the rolls. Harsh chemicals like toluene, acetone or MEK destroy the silicone covering of the rolls.
IMPORTANT
IMPORTANT
Raise the upper main roll when the image transfer laminator is not in operation. Prolonged contact can damage the rolls.
IMPORTANT
Do not leave the top roll heater on with the roll raised. Heat builds up in a stationary roll and can damage it.
IMPORTANT
Excess pressure can damage the rolls. Always select the minimum roll pressure necessary to complete the task.
IMPORTANT
If silicone adhesive contacts the upper or lower roll, remove it IMMEDIATELY using 80 % isopropyl alcohol. It can harden within an hour and ruin the roll.
IMPORTANT
flammable liquids and vapors. You can be injured by inhaling chemical vapors. Vapor build up or stored flammable liquids can cause a fire. Excessive dust can damage the image transfer laminator.
IMPORTANT
Do not use a knife or other sharp instrument during installation or while servicing the image transfer laminator. You can cause irreparable damage to the rolls.
© GBC |