GBC ORCA-IV Meaning, Audible Signal, Machine Reset Procedure, Table 3-1:Audible Signals

ORCA-IV Image Transfer Laminator Operation Manual Operation

6. Start the motor and increase the speed.

Kick Cable

Reset Button

Figure 3-3: Kick Cable Reset Button

Machine Reset Procedure

Perform this procedure whenever an emergency stop button or kick cable is activated or when the power to the machine is turned on.

1.Make sure all emergency stop buttons and kick cables are reset.

2.Press the main machine reset button above the power switch on the back of the machine. See Fig- ure 3-4: Machine Reset Button.

3.Check the web force settings to make sure they are what you require.

4.Restart the heater if it is being used.

5.Lock the shafts by closing the doors of the machine and pressing the shaft lock button or starting the motor.

ENCY	ST
R
E	OP
ME		AR
SU		R
A		ET
TO		D'
N		U
	ECN	R
		E

	Power
	Switch
Reset	w/ Lock
Button
Power	WARNING
	ACHTUNGMISE EN
	GARDE
Switch/
Lockout
	POWER

Figure 3-4: Machine Reset Button

$XGLEOH 6LJQDOV

For your safety, the machine has several audible signals that are used to alert you to the status of the machine. The following table lists the alert signals.

Table 3-1: Audible Signals

Audible Signal	Meaning
Continuous rapid beep	If the roll is down but
	not turning, the machine
	will begin beeping con-
	tinuously after 10 sec-
	onds.
Four beeps every 30 sec-	If the roll is up and the
onds after 55 minutes of	heater is on, the machine
inactivity	will begin beeping four
	times every 30 seconds
	after the machine has
	been inactive for 55
	minutes.
One beep per second	The machine is in
	reverse.

© GBC Pro-Tech 1998 October 3-3