GBC ORCA-IV 1-4:, Power, Reset, Power, Switch, Button, Switch, w/ Lock, Lockout, Fig- ure, Kick Cable, Reset Button, Machine Reset Button, Machine Reset Procedure

ORCA-IV Image Transfer Laminator Operation Manual Safety

Kick CableReset Button

Figure 1-3: Kick Cable Reset Button

Machine Reset Procedure

Perform this procedure whenever an emergency stop button or kick cable is activated or when the power to the machine is turned on.

1.Make sure all emergency stop buttons and kick cables are reset.

2.Press the main machine reset button above the power switch on the back of the machine. See Fig- ure 1-4: Machine Reset Button.

3.Check the web force settings to make sure they are what you require.

4.Turn the heater back on. It is necessary to restart the heater as all power is turned off when an emer- gency stop button or kick cable is activated.

5.Lock the shafts by closing the doors of the machine and pressing either the shaft locking switch or the FWD or REV arrow.

6.Start the motor and increase the speed.

☞Note

If the display does not have a decimal point in it, the machine needs to be reset.

ENCY	ST
R
E	OP
ME	AR
SU	R
A	ET
TO	D'
N	U
	R
	ECNE

	Power
	Switch
Reset	w/ Lock
Button
Power	WARNING
	ACHTUNGMISE EN
	GARDE
Switch/
Lockout
	POWER

Figure 1-4: Machine Reset Button

Despite the safety features built into the ORCA-IV, extreme caution must be used when operating or servicing the unit. READ THE FOLLOWING WARN-

INGS AND CAUTIONS BEFORE ATTEMPTING TO OPERATE OR SERVICE THE ORCA-IV IMAGE TRANSFER LAMINATOR.

WARNING

Secure long hair so that it cannot get caught in the machinery. Do not wear ties, loose fitting clothing or dangling jewelry while cleaning or servicing the image transfer laminator. These items can get caught in the nip and choke you or you can be crushed or burned.

IMPORTANT

Use a lift to load and unload rolls larger than 50 yards. They can weigh up to 500 lbs and can crush you.

© GBC Pro-Tech 1998 October 1-3