OVEN CONTROL, CLOCK Am TMER
L.ck
The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be changed during a Timed Baking or
To Set the Clock
1. Press the CLOCK pad.
(uCLOCK
A
2.Press the INCREASE or DECREASE pad to set the time of day.
@
A
3. Press the CLOCK pad to start.
~imer
“~he timer does not control oven operations. The maximum setting on the timer is 9 hours and 55 minutes.
To Set the Timer
1.Press the TIMER
❑TIMER ON/OFF pad.
ON/OFF
A
2.Press the INCREASE or DECREASE pad to
@set the amount of
A
time on the timer.
e
v
The timer will start automatically within a few seconds of releasing the INCREASE or DECREASE pad. The timer, as you are setting it, will display seconds until one minute is reached.
Then it will display minutes and seconds until 60 minutes is reached.
After 60 minutes, it will display hours (“HR” now appears in display) and minutes until the maximum time of 9 hours and 55 minutes is reached.
To Reset the Timer
If “TIMER” is displayed, press the INCREASE or DECREASE pad until desired time is reached.
If “TIMER” is not displayed, press the TIMER ON/OFF pad first, then follow the instructions above (o set the timer.
To Cancel the Timer
Press ;nd hold the TIMER ON/OFF pad until the word “TIMER” disappears from the display.
End of Cycle Tone
The end of cycle tone is a series of three beeps followed by one beep every six seconds. [f you would like to remove the signal that beeps every six seconds,
press and hold the CLEAR/OFF .uad for 1() seconds.
.—
eturn the signal that beeps every six seconds,
.,s and hold the CLEAR/OFF pad for 10 seconds.
Power Outage
After a power outage, when power is restored, the display will flash and time shown will no longer be
The display flashes until the clock is reset. All other functions that were in operation when the power went out will have to be programmed again.