Unit beeps
•Clean charging contacts on cordless handset.
•See solutions for “No dial tone”.
•Replace the battery.
Memory Dialing doesn’t work
•Did you program the memory location keys correctly?
•Did you follow proper dialing sequence?
Unit locks up and there is no communication between the base and cordless handset
•Unplug the AC power adaptor from the wall outlet and the back of the base. Remove the handset battery. Wait for 30 seconds and plug the power adaptor back into the base and wall outlet. Reconnect the battery and charge for 16 hours.
Handset displays SEARCHING or OUT OF RANGE and cannot link up with the base when the TALK button is pressed.
•Handset may be out of range of the base. Move closer to the base.
•Make sure the power adaptor is properly installed.
•Disconnect the handset battery and plug it in again. Place the handset on the cradle for at least 2 to 3 minutes.
•Disconnect the power adaptor and plug it in again. Then place the handset on the cradle for at least 2 to 3 minutes.
Handset displays HANDSET NEEDS REGISTRATION
•Follow the programming in the telephone procedures to
•Press the Select (SKL) button to begin handset registration. Follow instructions on Handset screen.
Caller ID Solutions
No Display
•Charge the battery (for 16 hours). Or replace the battery.
•Make sure that the unit is connected to a
Caller ID Error Message
•The unit displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates the presence of noise on the line.
60
