Controls—terminal connections.
Safety Instructions
Operating Instructions
Care and Cleaning
Controls–Terminal Connections
The terminal connections are located behind the front case panel through an opening on the front of the unit.
To access the terminal connections, remove the front panel by removing the filter, taking out the four front screws, the upper two screws from the top of the panel and the shipping screws on each side, if present. (Discard the two side shipping screws, if present).
Insert the building
Route the wires from the terminal connections through the unit wire guides and out through the case wire guide.
NOTE: The owner is responsible for setting the appropriate dip switches and connecting terminals.
CAUTION:
Improper CDC wiring may damage the Zoneline electronics or cause erratic Zoneline operation. No common busing is permitted. A separate wire pair must be run from each separate controlling switch to each individual Zoneline.
Terminal connections
Route wires through wire guides
Troubleshooting Tips
Room Air Sensor
Motion Sensor
Door Sensor
Central Desk Control
Consumer Support
Room Air Sensor (Requires room air sensor kit – RAVRMS)
When connected, the room air sensor will allow utilization of the temperature limiting and freeze sentinel features.
NOTE: If GE thermostat RAK147P2 or RAK163P2 |
|
|
|
|
is used with the unit, the room sensor kit is not |
|
|
|
|
needed, since temperature limiting and freeze |
| Room Air | ||
sentinel features are incorporated in the |
| |||
| Sensor | |||
thermostats. |
| |||
|
|
|
|
6