Read these instructions completely and carefully.
Replace the Power Cord (Optional) Continued
Perform this step only if the power cord shipped on the range does not match your wall receptacle.
4-Wire Conduit Installation Option
Safety Instructions
Remove the strain relief clamp from the bracket.
Assemble the squeeze connector (obtained locally), matching the diameter of your conduit, in the bracket hole. Insert the conduit through the squeeze connector. Allow enough slack to easily attach the wires to the terminal block.
NOTE: Do not install the conduit without a squeeze connector.
Insert the ground bare wire tip between the range frame and the ground plate (removed earlier) and secure it in place with the ground screw (removed earlier). Insert the bare wire (white/neutral) tip through the bottom center of the terminal block opening. Insert the two side bare wire tips into the lower left and the lower right terminal block openings. Tighten the screws until the wire is firmly secure (approximately 20
NOTE: Make sure the wire is completely inserted into the terminal block and a secure connection is made.
Secure the squeeze connector in place in the bracket by tightening the squeeze connector screws.
NOTE: ALUMINUM WIRING:
Squeeze connector
Conduit 
Terminal block
Wire tips
Ground screw
Bracket
Ground plate (grounding to range)
Bracket
Operating Instructions
Instructions | Installation |
|
|
Aluminum building wire may be used but it must be rated for the correct amperage and voltage to make connection.
Wire used, location and enclosure
of splices, etc., must conform to good wiring practices and local codes.
Troubleshooting
Replace the Wire Cover
Replace the wire cover on the range back by sliding its right edge under the retaining tab and replacing the two screws removed earlier. Make sure that no wires are pinched between the cover and the range back.
2screws to replace wire cover
Retaining tab
Wire 
cover
Tips Consumer
Back of range
49
Support
