Installation Instructions
12ATTACH WASHER CONTROL BOARD TO NEW BACKSPLASH
Replace the four screws removed from the control board earlier.
The control board will now be on the opposite side of the washer backsplash.
13RECONNECT WASHER CONTROL BOARD
Connect the washer control board to the new backsplash by sliding the ribbon connector on the new backsplash onto the metal pins on the control board and pushing in. Make sure the ribbon is not twisted before inserting the connector.
14ATTACH WASHER BACKSPLASH
Using the two small screws removed earlier, screw the new washer backsplash onto the rear cover.
Screws
Place the gray wire from the serial port under the strain relief on the new backsplash.
Strain Relief
Insert the tabs on the bottom front of the backsplash into the slots on the washer and rotate the backsplash into place. Press the rear of the backsplash down to make sure it fits properly.
Secure the new backsplash to the washer using the two long screws removed earlier.
15RECONNECT POWER SUPPLY TO WASHER AND DRYER
•Plug the washer and dryer back in.
•Press the POWER buttons on both the washer and dryer to make sure both control boards are properly connected.
28
