
Installation Instructions
2ATTACH WATER HOSES TO WASHER
Thread the hot water hose onto the washer hot water connection (ORANGE) and the cold water hose onto the cold water connection (BLUE). Hand tighten; then make an additional 1/8 turn with pliers.
Hot
Cold
4CONNECT WATER HOSES TO HOUSE UTILITIES
Connect the water hoses to the HOT and COLD water valves of your home. Hand tighten, plus make an additional 1/4 turn with pliers.
3MOVE WASHER CLOSE TO HOUSE UTILITIES
Move the washer as close to the final location as possible, leaving enough room to make water, drain and electrical connections to the home.
The minimum required rear clearance is 3”.
3”
5ATTACH DRAIN HOSE TO HOUSE DRAIN
Firmly insert the free end of the drain hose into the drain opening of your home. Make sure the soft rubber end is completely inside the drain opening.
•If the water valves and drain are built into the wall, fasten the drain hose to one of the water hoses with the cable tie (ribbed side on inside).
•If your drain is a standpipe, fasten the drain hose to the standpipe with the cable tie provided.
Cable Tie Cable Tie
22