Suflace Light and Starter (on some models)
Do not touch the btib when it is hot or with wet hands. Never wipe the tight area with a wet cloth. Electrical power must be shut off if you have to replace a broken bulb.
To replace the btib:
1.flip the front of the hinged canopy up.
2.Remove the fluorescent light bulb. Replace the bulb with one of the same length and wattage.
3.hwer the canopy.
To replace the stirter:
1.Open the canopy and remove the bulb as explained above.
2.Grasp the starter, turn it counterclockwise, about one quarter turn and lift out. Replace with one of the same wattage.
3.Reposition the bulb and lower the canopy.
CanopyBulb
Statier
=::_.
A.\
ControlPanel and mobs
It’s a good idea to wipe the control panel after each use of the oven. Clean with mild soap and water or vinegar and water, rinse with clean water and polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleansers, plastic scouring pads or oven cleansers on the control
The control knobs may be removed for easier cleaning.
Before removing the knobs for clwning, please note that the knobs on the left side and the knobs on the right side are in the proper 0~ position. When replacing the knobs, check the 0~ position to insure proper placement.
To remove the knob, pull it straight off the spring clip. If it is difficult to remove, place a thin cloth (like a handkerchief or a piece of string under and around the knob edge and pull up.
The knob stem has a groove in each side. The groove on one side has a spring clip. The other groove is clear (see illustration). Check the inside of the knob and find the molded rib. Replace the knob by fitting the molded rib inside the knob into the clear groove on the stem. Wash the knobs in soap and water or a
Clear Groove
in Stem
Glass Sufiaces
To clean the outside glass finish, use a glass cleaner. Rinse and polish with a dry cloth. Do not allow the water or cleaner to run ~own inside openings in the top of the oven door while cleaning.
Painted Sufiaces
Painted surfaces include the outside oven door, sides, control panel and drawer front. Clean these with soap and water or a vinegar and water solution.
Do not use commercial oven cleaners, cleansing powders, steel wool or harsh abrasives on any painted surface.
Metal Parts
Do not use steel wool, abrasives, ammonia or commercial oven cleaners. To safely clean surfaces; wash, rinse and then dry with a soft cloth.
(continued next page)
29
