Care and Cleaning
(See Cleaning Guide)
Proper care and cleaning are
impoIlant so yoLw range will give
yOLI efficient and satisfactory service.
Follow’ these directions carefully in caring for yOLH- range to assure safe and proper maintenance.
Cooktop
The porcelain enamel cooktop is sturdy but breakable if misused. This t’inish is
However, any food spills with a high acid content (such as fnlit juices, tomato or
Cleaning Under the Range
The area LInclcr the range of models equipped with a bottom drawer can be reached easily for cleaning by removing the bottom drawer. To
remove, pLIll drawer oLlt all the way, tilt Llp the front and remove
it. To replace. insert glides at back of drawer beyond stop on range
ml ides. Lift
insert easily. Let front of drawer down, then pLlsh in to close.
Removable Oven Door
r1
r!
To REMOVE door, open to BROIL position. or where yoLl feel hinge catch slightly. Grasp door at sides: lift door up and away from hinges.
To REPLACE, grasp door at sides.
Line LIp door with hinges and push
door firmly into place.
22
Oven Vent Duct
Your range is vented through a duct located under the right rear surface unit. Clean the duct often.
\/
Tb remokre:
●Make sure unit is cool.
●Lift LIp right rear surface unit.
●Remove drip pan/trim ring.
●Lift out oven vent duct.
To replace:
●Place the part over the oven vent located below the cooktop with opening of the duct under the round opening in the drip pan. It is important that the duct is in the correct position so moisture and vapors from the oven can be re~eased during oven use. NOTE: Never cover the hole in the oven vent duct with aluminum foil or any other material. This prevents the oven vent from working properly during any cooking cycle.
Lamp Replacement
CAUTION: Before replacing your oven lamp bulb, disconnect the electric power for your range at the main fuse or circuit breaker panel. Be sure to let the lamp cover and bulb cool completely before removing or replacing them.
The oven Imp (bulb) is covered with a glass removable cover which is held~n place with a
To remove:
. Hold hand under cover so it doesn’t fall when released. With fingers of same hand, firmly push back wire bail until it clears cover. Lift off cover. DO NOT REMOVE ANY SCREWS.
. Replace bulb with
To replace cover:
●Place it into groove of lamp receptacle. Pull wire bail forward to center of cover until it snaps into place. When in place, wire holds cover firmly. Be certain wire bail is in depression in center of cover.
. Connect electric power to range.
Surface Units
Clean the area under the drip pdtrim rings often.
are removable.
Caution: Be sure all controls are turned to OFF and surface units are cool before attempting to lift or remove them.
After 
1 ifting the
a damp cloth or sponge.
—
