www.GEAppliances.ca

Problem

 

Possible Causes

What To Do

 

 

 

 

 

“F – and a number

 

You have a function

Press the OFF pad. Put the oven back into

or letter” flash

 

error code.

operation.

in the display

 

 

 

 

 

If the function code repeats. Disconnect all power to the range for at least 30

 

 

 

 

 

 

seconds and then reconnect power. If the function

 

 

 

 

error code repeats, call for service.

 

 

 

 

If a function error code appears during the

 

 

 

 

self-cleaning cycle, check the oven door latch.

 

 

 

 

The latch may have been moved, if only slightly,

 

 

 

 

from the locked position. Make sure the latch is

 

 

 

 

moved to the right as far as it will go. Press the OFF

 

 

 

 

pad. Allow the oven to cool for one hour. Put the

 

 

 

 

oven back into operation.

 

 

 

 

Display flashes “bAd”

 

The installed connection

Contact installer or electrician to correct miswire.

then “linE” with a

 

from the house to the unit

 

loud tone

 

is miswired.

 

 

 

 

 

Display goes blank

 

A fuse in your home may be

Replace the fuse or reset the circuit breaker.

 

 

blown or the circuit

 

 

 

breaker tripped.

 

 

 

 

 

 

The clock is turned off from See the Using the clock and timer section.

 

 

showing in the display.

 

 

 

 

 

Display flashes

 

Power failure.

Reset the clock.

 

 

 

 

Unable to get the

 

Oven control pads were

The BAKE and BROIL pads must be pressed

display to show “SF”

 

not pressed properly.

at the same time and held for 3 seconds.

 

 

 

 

Power outage,

 

Power outage or surge.

Reset the clock. If the oven was in use, you must reset

clock flashes

 

 

 

it by pressing the OFF pad, setting the clock and

 

 

 

 

resetting any cooking function.

 

 

 

 

“Burning” or “oily”

 

This is normal in a new

To speed the process, set a self-clean cycle for a

odor emitting from

 

oven and will disappear

minimum of 3 hours. See the Using the self- cleaning

the vent

 

in time.

oven section.

 

 

 

 

Strong odor

 

An odor from the insulation

This is temporary.

 

 

around the inside of the

 

 

 

oven is normal for the first

 

 

 

few times the oven is used.

 

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips

No power supply from convenience outlet on top of backguard (on some models)

Small appliance plug is not

Make sure the small appliance plug is properly

completely inserted in the

inserted.

convenience outlet.

 

 

 

The backguard is too hot

Allow the range to cool, then reset the circuit

and the convenience outlet

breaker by pressing the switch located near the

breaker has tripped.

convenience outlet.

Consumer Support

33

Page 33
Image 33
GE JCBP71, JCBP67, JCBP65, JCBP70, JCBP83, JCBP78, JCBP81, JCBP80, JCBP66, JCBP68, JCBP62, JCB710, ECBP82 owner manual Consumer Support