![](/images/new-backgrounds/1090444/9044489x1.webp)
❑CONVERTING SURFME BURNERS ON MODELS EQUIPPED WITH S~LED BURNERS (See
Step 4 if range is equipped with dual burners.)
Burnercap~
Burner Head
Bu::a
Orifice Spud
Gas Inlet Tube |
|
| ) | |
\ |
| |||
|
|
|
1.Remove grates, burner caps and burner heads.
2.Remove burner bases by unscrewing the 3 small screws in each base. ~ burner strti@t out.
DO NOT disconnect the wires from the burner bases unless the cooktop needs to be raised.
3.With 7mm or 5/16” wrench (depending on the size of your spuds), remove the 4 brass orflce spuds.
4.Install orifice spuds accordin to one of the following diagrams (see ❑ ordB ), for LP
gas or natural gas, depending on which you are converting to.
❑Orifice Spuds brConve~ingto U&:
LP orifice spuds are in a small plastic bag packed with this Use and Care book. LP orifice spuds have a
one side. Each orifice spud will also have 1 or 2 grooves on one side, denoting the location on the range where it is to be installed.
❑Orifice Spuds ferConVefiing to Natural Gas:
Natural gas orifice spuds have a
Front of Range
(continued next page)
45
—