CLOCK Am TMR
Follow the directions below if your range has the clock and timer shown at the right.
The electronic range clock and timer allow you to set the timer up to 9 hours and 45 minutes. You have the choice of having the timer show the time counting
down or the time of day. In either case, the timer will signal at the end of the timer period to alert you that the time is up.
H[-]
TIMER
n
To Set the Clock
NOTE: When you first plug in the range or after
a power failure, the entire Cloc~imer display will light up. After several seconds “12:00” will then flash on the display.
1.Press the CLOCK pad. “12:00” stops flashing and “SET TIME” flashes on the display.
2.Press and hold the UP or DOWN pad and the time of day will change 10 minutes at a time. To change the time by single minutes, give the pads short taps.
For example, to set the clock for 3: 15, press and hold the UP pad until ’63:10” appears, and then tap the UP pad until “3:15” is displayed.
3.Press the CLOCK pad and the clock will be set. If you do not press the CLOCK pad, the clock will automatically be set within one minute.
To Set the Timer
1.Press the TIMER pad. “:00” appears on the display and “SET TIMER” flashes.
2.Use the UP and DOWN pads to set the timer. Short taps on the UP or DOWN pad change the timer’s setting one minute at a time. Pressing and continuing to hold the UP pad increases the setting five minutes at a time until one hour (“1:00”) is displayed. After one hour is displayed, pressing and holding the UP pad increases the setting
15 minutes at a time. (Short taps on the UP and DOWN pads will always change the setting by
3.To start the timer, press the TIMER pad.
If the TIMER pad is not pressed, the timer will automatically start after a few seconds.
As the timer counts down, a single beep will indicate when one minute is left. After this beep, the display will count down in seconds. When the timer reaches “:00~’ you will hear three sets of three short beeps, and then a single beep every 10 seconds for 10 minutes or until you press any of the Cloc~imer pads.
To Change or Cancel the Timer Setting
When the timer is counting down, use the UP and DOWN pad to change the remaining time, or press the TIMER pad to cancel the timer function. The timer function cannot be cancelled until “SET TIMER” stops flashing and “TIMER” appears on the display.
To Display the Time of Day While the Timer Is Operating
Pressing the CLOCK pad while the timer is operating will not interfere with the timer’s operation; the display will change to show the time of day, but the timer will continue to count down and will still signal when time is up. Simply press the TIMER pad again to change the display back to show the timer function.
(continued next page)
11
—
