GE JGSS05GES, JGSS05GER, JGBS15GER, JGBS12GER ELECTRl~L CONNECTIONS continued, Electric Disconnect

ELECTRl~L CONNECTIONS (continued)

❑USage Sitiation.where Appliace Power Cord ~ be Disconnected I&equen@.

An adapter maybe used only on a 15-amp circuit. Do not use an adapter on a 20-amp circuit. mere local codes permit, a ~MPOHY CONNE~ON may be made to a properly grounded two-prong wall receptacle by the use of a UL-listed adapter, available at most hardware stores. The larger slot in the adapter must be aligned with the larger slot in the wall receptacle to provide proper polarity in the connection of the power cord,

TEMPORARY METHOD		~~
(ADAPTER PLUGS NOT		I ‘~k.,- o >
PERMITTED IN CANADA)		2’
		d
		.,,
ALIGN LARGE	:“7
		ENSURE PROPER
PRONGS/SLOTS	Q	GROUND AND
		FIRM CONNECTION

BEFORE USE

CA~ON: Attaching the adapter ground terminal to the wall receptacle cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall receptacle is grounded through the house wiring. The customer should have the circuit checked by a qualified electrician to make sure the receptacle is properly grounded.

men disconnecting the power cord from the adapter, always hold the adapter with one hand. H this is not done, the adapter ground terminal is very likely to break with repeated use. Should this happen, DO N~ USE the appliance until a proper ground has again been established.

❑Usage Situations where Appliance Power Cord ~ be Disconnected Frequen&.

Do not use an adapter plug in these situations because disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal. The customer should have the two-prong wall receptacle replaced with a three-prong ~rounding) receptacle by a qualified electrician before using the appliance.

The installation of appliances designed for mobile home installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Stindard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard for Manufactured Home Installations, latest edition (Manufactured Home Sites, Communities and Set-Ups), ~SI A225.1, latest edition, or with local codes. In Canada, mobile home installation must be in accordance with the current CN/CSA Z240/MH Mobile Home Installation Code.

Electric Disconnect

1.Locate disconnect plug on the range back.

2.Pinch sides of connector and pull out of range back.

You will have one of these disconnect plugs.

.--,3	--
	_=—
p,, !	.~~
	7

F

w

34