HOW TO CONVE~ THE RANGE FOR USE
WITH 1P GM OR NATURAL GAS
TOOLS REQUIRED:
Nut drivers or wrenches: 7mm or 5/16” (depending on the size of the spuds)
❑PREPARE RANGE FOR CONVERSION
(1) Turn off gas supp~ at tie wall.
(2) Turn off the electicd power to tie range.
If range has not yet been connected to gas supply, or if flexible connection was made, range maybe pulled out from the wall to make conversion easier.
❑CONVERT THE PRESSURE REGULATOR
W~~G: Do not remove the pressure regulator from the range.
1.For models equipped with sealed burners, remove the storage drawer, broiler drawer or kick panel and locate the pressure regulator at rear of the range.
Remove Screws~
Access Cover
On some models, you may have to remove an access cover also.
For models equipped with dual burners, remove the cooktop and locate the pressure regulator at right rear of range.
2.Follow the directions in❑A or Bn that match your regulator type.
Is the e in a ation.
If it is this regulator:
1.Use a coin to remove the cap from the pressure regulator.
2.Turn the cap over and hook it into the slots. The type of gas to be used should now be visible on the top of the cap.
Note: On some models the
E may be in a different location.
U it is this regulator:
1.Unscrew the
2.Carefully pry the protective plastic cap off the threaded metal cap. Gently pull the plastic washer off the threads on the other side of the metal cap.
3.Push the plastic cap onto the end of the metal cap displaying the type of gas you are converting to. Press the attached plastic washer onto the threads on the other side of the metal cap.
4.Screw the
