Jock | To Set the Clock | |
The clock must be set for the |
| 1. Press the |
automatic oven timing functions to | CLOCK | CLOCK pad. |
work properly. The time of day |
| |
cannot be changed during a Timed | ❑ |
|
Bake or CLEAN cycle. |
| |
2.Press the
TA INCREASE or DECREASE pad
~to set the time of day.
3. Press the CLOCK pad to start.
Timer
The timer is a minute timer; it does not control oven operations. The maximum setting on the timer is
9 hours and SS minutes.
To Set the Timer
1.Press the TIMER
TIMER ON/OFF pad.
ONIOFF 7
2.Press the INCREASE or DECREASE pad to set the amount of time on timer.
The timer will start automatically within a few seconds of releasing the INCREASE or DECREASE pad.
The timer, as you are setting it, will display hours and minutes; “HR>’ will be in the display.
During the countdown, when the timer reaches the last minute, the display will change to seconds only and a single beep will sound.
J Reset the Timer | To Cancel the Timer |
If “TIMER’- is flashing, press the INCREASE or DECREASE pad until the desired time is reached.
If “TIMER” is not flashing, press the TIMER ON/OFF pad first, then follow the instructions above to set the timer.
Press the TIMER ON/OFF pad while the word “TIMER” is flashing.
End of Cycle Tone
The end of cycle tone is a series of 3 beeps followed by I beep every 6 seconds. If you would like to remove the signal that beeps every 6 seconds, press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press and hold the CLEAR/OFF pad for 
I () seconds.
Power Outage
After a power outage, when power is restored, the display will flash and time shown will no longer be
other functions that were in operation when the power went out will have to be programmed again.
7
