Using the clock, timer and control lockout.

www.GEAppliances.com

 

To Set the Clock

 

 

The clock must be set to the correct time

Select SETTINGS.

 

of day for the automatic oven timing

Select CLOCK.

Make sure the clock is set to the

functions to work properly. The time of

 

day cannot be changed during timed

Press the number pads.

correct time of day.

 

baking, a self-cleaning cycle or delayed

Select ENTER.

 

start time.

 

 

Safety Instructions

KITCHEN

TIMER

The timer is an hour and minute timer only.

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

To set 10 minutes, enter 10. DO NOT enter 10:00!

To Set the Timer

Press the KITCHEN TIMER pad.

Press the number pads until the amount of time you want shows in the display. For example, to set 2 hours and 45 minutes, press 2, 4 and 5 in that order. If you make a mistake, press the KITCHEN TIMER pad and begin again.

Select START.

After selecting START, SET disappears; this tells you the time is counting down, although the display does not change until

one minute has passed. Seconds will not be shown in the display until the last minute is counting down.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER pad is pressed once.

The continuous beep can be canceled by following the steps in the Settings section under Tones at the End of a Timed Cycle.

Operating Instructions Care and

To Reset the Timer

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the KITCHEN TIMER pad or using

REVIEW TIMES.

You may change it by pressing the KITCHEN TIMER pad, then press the number pads until the time you want appears in the display.

Cleaning

To Cancel the Timer

Press KITCHEN TIMER pad twice.

Troubleshooting

CONTROL

LOCK

Control Lockout

Your control will allow you to lock out the touch pads so they cannot be activated when pressed.

To lock/unlock the controls:

Press the CONTROL LOCK pad for 3 seconds, until the control screen

shows CONTROL IS LOCKED.

To unlock the control, press the CONTROL LOCK pad for 3 seconds, until CONTROL IS LOCKED disappears from the control screen and the main menu is displayed.

When this feature is on and the touch pads are pressed, the control will show

CONTROL IS LOCKED.

The control lockout mode affects all touch pads.

The control will remain locked after a power failure.

Tips Consumer Support

17

Page 17
Image 17
GE JS998 owner manual Safety Instructions, Cleaning