Operating Instructions Safety Instructions

Care and cleaning of the range.

Painted Surfaces

 

Painted surfaces include the door,

Do not use commercial oven cleaners,

 

top of the control panel and the drawer

cleaning powders, steel wool or harsh

 

front. Clean these with soap and water or

abrasives on any painted surface.

 

a vinegar and water solution.

 

 

 

Roasting rack

Oven Racks and Convection Roasting Rack

 

Clean the oven racks and the convection

NOTE: The oven racks and convection roasting

Oven rack

roasting rack with an abrasive cleanser or

rack may be cleaned in the self-cleaning oven.

 

steel wool. After cleaning, rinse the racks

However, the oven racks will darken in color,

with clean water and dry with a clean

lose their luster and become hard to slide if

cleaned during the self-cleaning cycle.

cloth.

 

 

To make the oven racks slide more easily,

 

apply a small amount of cooking oil to a

 

paper towel and wipe the edges of the

 

oven racks with the paper towel.

Consumer Support Troubleshooting Tips Care and Cleaning

ReceptacleSocket

Bulb

Screen

Tab

Glass cover

Oven Light Bulbs

NOTE: The glass cover should be removed only when cold. Wearing latex gloves may offer a better grip.

CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel.

Be sure to let the light cover and bulb cool completely.

For your safety, do not touch a bulb with bare hands or a damp cloth. It can also shorten the bulb life.

To remove:

Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket.

Using gloves or a dry cloth, remove the bulb by pulling it straight out.

To replace:

Use a new 130-volt Halogen bulb, not to exceed 50 watts.

Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers.

Receptacle

Use gloves or cloth

Push the bulb straight into the receptacle all the way. Then replace the screen.

NOTE: The screen must be replaced or the life of the bulb will be reduced.

Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn.

For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.

Reconnect electrical power to the oven.

44

Page 44
Image 44
GE JS998 owner manual Operating Instructions Safety Instructions, Painted Surfaces, Oven Racks and Convection Roasting Rack