GE JSP60GN manual OW to Insert the Module, Melted Materials on the Module

..OW to Insert the Module

are turned to OFF, To >Y”<~’- .\.<<--~; ..-—

‘“;;;;;;;:.,~-

!:!~:sfi::i::.-: There you will see b

the electrical receptacle. A receptacle is available in either cooktop opening. Allow the leading corners of the module to rest on the cooktop surface.

2.Carefully slide the module plug toward the receptacle Lln[i] pILIg is engaged completely in the receptacle. Allow the module to fit into the cooktop opening.

3.Lower the inside edge of the module into the cooktop opening until it is flush with the cooktop surface.

How to Remove the Module

Be sure the entire module surface is cool before attempting to remove the module. The glass surface of the module will retain heat after the controls have been turned off. Be careful not to get burned on a module that has not had sufficient time to cool after use.

1.Lift the finger tab at the outside edge of the module until the module base clears the cooktop opening.

2.Hold the module by the front and rear edges. Carefully slide the module away from the cooktop center until the module plug is disengaged from the electrical receptacle. Store the module carefully after cleaning.

General Information About Radiant Modules

The radiant module features heating coils beneath a smooth glass ceramic surface. The 2 surfaces units are shown by out] ines on the glass.

Vhen a surface unit is activated. coils beneath the Llnit radiate heat through the glass to the cookware. The red glow of the coils will be instantly visible through the glass. It will take the surface unit on the surface a few moments to heat up. The coil cycles on and and off to maintain your selected control setting. The coils have temperature limiters to prevent runaway temperatures.

●Use the same cookware that you would use with solid disk elements.

“If you are storing modules, do not stack them or store other materials on top of them. as damage to the glass ceramic surface of the radiant module is likely. Be careful not to damage or bend the electrical plLIg.

●Do not let pots boil dry. Overheated metal can bond to glass module. An overheated copper pot will leave a residue that will permanently stain the module.

●S1 iding alum inure cookware across the glass may leave metal marks. These metal marks will appear as small scratches. They can be removed with Cook Top Cleaning Creme and a razor scraper.

●When a surface unit is turned on, the unit can be seen glowing red within a few seconds. The red glow will turn on and off (cycling) to maintain the selected heat setting. With poor cookware, you will see frequent cycling of the unit off and on. Good, flat cookware will minimize the cycling.

e It is saf-e to place hot cookware from the oven or surface on the glass ceramic surface when it is cool. Hot cookware will not damage the surface.

Melted Materials on the Module

Melted materials (plastic, tiluminurn foil, sugar or foods with high sugar content) can cause damage to the module.

If you accidentally melt anything	‘ =,	-
on the module, turn the unit to LO,	~’ :	~
wipe the hot module immediately	’,,, ,.
“- ‘rith several dry paper towels.	!’	,/’	‘“
earing an oven mitt, hold a razor
	--“/9
scraper at a 30° angle to the module

and ;crape the hot ~pill to a cool area outside

of’ the surface unit. Be careful not to burn yourself.

Do not attempt further cleaning until the module surface has cooled. See the Care and Cleaning section.

NOTE: Be sure to use a new, sharp blade in the razor scraper. Do not use a dull or nicked blade.

15

.-