GE JSP60GN manual Radiant Module, For heavy, burned on soil, Special Care, General Information

Radiant Module

Cleaning of glass ceramic

is different from cleaning a

r=

standard porcelain finish.\>-

\ — ./-” -

To maintain and protect the surface of your new glass ceramic module follow these basic steps.

DAILY CLEANING:

Use only Cook Top Cleaning Creme on Glass Ceramic.

For normal, light soil:

1.Rub a small amount of Cook Top Creme onto soiled area using a dry paper towel. Wipe until all soi] and creme are l“emoved. F1-equent cleaning leaves a protective coating of silicone which is essential in preventing scratches and abrasions.

2.Clean surface with Cook Top Cleaning Creme after each use.

For heavy, burned on soil:

1.Apply a few drops of Cook Top Cleaning Creme to the (cool) soiled area.

2.Using a dry paper towel, rub creme into the burned on area.

3.Carefully scrape remaining soil with razor scraper. Hold scraper at 300 angle against the ceramic surface.

4.If any soil remains, repeat the steps listed above. For additional protection, after all soil has been removed, polish the entire surface with the Cook Top Cleaning Creme.

NOTE:

●Using a razor scraper will not damage the surface if the 30°angle is maintained. Store the razor scraper out of reach of children.

●Be sure to use a new, sharp razor scraper. Do not use a dull or nicked blade.

Special Care:

Sugary spillovers (such as jellies, fudge, candy syrups) or melted plastics can cause pitting of the surface of your module unless the spill is removed while still hot. Special care should be taken when removing hot substances. Follow these instructions carefully and remove soil while spill is still hot.

1.Turn off all surface units affected by the spillover. Remove hot utensils.

2. Wearing an oven mitt, hold the razor	---
scraper at a 30° angle to the module ““; ;. -
and scrape the hot spill to a cool area	2,+4.,
	y’
outside the surface unit. Be sure to use

a new, sharp razor scraper. Do not use a dull or nicked blade.

3.With the spill in a cool area, use a dry paper towel to remove-any excess. Any spillover”r~mai ning should be left until the surface of the cooktop has cooled. Do not continue to use the soiled surface unit until all of the spillover has been removed. Follow the steps under Heavy Soil to continue the

cleaning t3rocess.

-.

General Information:

As the Cook Top Cleaning Creme cleans, it leaves a protective silicone coating on the module surface. This coating helps to prevent build-up of mineral deposits (water spots) and will make future cleaning easier. Dishwasher detergents remove this protective coating and therefore make the cooktop more susceptible to staining.

PRECAUTIONS:

●Most cleaners contain ammonia, chemicals and abrasives which can damage the surface of your cooktop. Use only the Cook Top Cleaning Creme for proper cleaning and protection of your glass ceramic surface.

●If you slide aluminum or copper cookware across the surface of your cooktop, they may leave metal markings which appear as scratches. If this should happen, use the razor scraper and Cleaning Creme to remove these markings. Failure to remove these residues immediately may leave permanent marks.

s If pots with a thin overlay of aluminum, copper, or enamel are allowed to boil dry, the overlay may bond with the glass ceramic and leave a black discoloration. This should be removed immediately before heating again or the discoloration may be permanent.

0 Use of window cleaner may leave an iridescent film on the cooktop. Cook Top Cleaning Creme will remove this discoloration.

●Water stains (calcium deposits) are removable using Cook Top Cleaning Creme or fu!l strength white vinegar.

(continueci next ixzge)

35