OVEN CONTROL, CLOCK AND TIMER

(continued)
To Delay Starting an Automatic Oven Operation
If a delayed cooking operation is desired:
1. Push the
COOK
TIME button.
2. Set length of baking time with the SET knob.
3. Push the STOP TIME button.
NOTE: You can push the STOP TIME button
to
find
out when the oven will turn off.
●
Foods that are highly perishable,
such as milk,
eggs, fish, stuffings, poultry and pork should not
be allowed to sit out for more than I hour before
4. Turn the
SET knob to the time of day when baking or after cooking. Room temperature promotes the
should be completed. The control will not permit growth of harmful bacteria.
you to set a stop time that is less than the length
of
●
If a delayed self-cleaning oven operation is desired,
cooking time plus the current time of day. see the Self-Cleaning Oven section.
5. Pusb the BAKE button.
6. Turn the SET knob to the desired temperature.
When the stop time is reached, the End-of-Cycle
Tone will sound and the oven will turn off.
Tones
End-of-Cycle Tone (3
long beeps— 1 second on,
1
second off): shows that a timed oven operation has
reached STOP TIME or that the Minute/Second Timer
has counted down.
Attention Tone
(series of short beeps, l/4-second on,
l/4-second off, until proper response is given): will
sound if oven has only been partially programmed.
For example, if
yOLI
have selected a cook time but no
tempei”ature,
you will hear the Attention Tone
until
you select a temperature or push CANCEL button.
Notification Tone
(single, l-second beep): indicates
the oven has stabilized at the selected temperature.
Key Tone
(single, l/10-second beep): sounds when
any button
]s
pushed.
Function Error Tone
(series of very rapid beeps,
l/8-second on, l/4-second
oft>.
The display will show
a Function Error Code, “F 1,“ “F2,” etc. Cancel the
Function Error Tone by pushing the CANCEL button.
If the Function Error Tone starts again (after about
15 seconds), call f-or service, mentioning the code that
appeared. Disconnect the range electrical supply to
stop the tone.
If the function error occurred while you were
programming the control, push the CANCEL button
and try again.
To Cancel the Tone...1f
you don’t want an audible
tone when you push a button, you can eliminate the
Key Tone by pushing and holding the CANCEL
button until you hear a short beep (in approximately
2 seconds). To activate the tone again, push and hold
the CANCEL button once more until you hear a short
beep. Canceling or activating the tone should only be
done when there is no oven operation programmed.
Pushing the CANCEL button will clear all functions
except the Clock and Timer.
How to Change a Program
When a function has been entered, you can recall what has been
programmed by pushing the corresponding function button. The messages
in the display show you which function is currently being displayed. While
the function is displayed, you can change it with the SET knob. You can
change any programmed function at any time.
24