Installation Instructions

UNPACKING THE COOKTOP/INSTALLING THE GASKET

7INSTALLING THE FOAM GASKET AND REFLECTIVE TAPE

CAUTION: Potential risk of fire – reflective tape must be secured around countertop opening as shown.

Do not install the cooktop into the countertop without installing the foam gasket as shown. It protects the bottom edge of the glass from the countertop and seals the cooktop against spills.

Remove the cooktop along with its shipping pad from the shipping box. Remove the shipping block from the downdraft vent opening and place it under the shipping pad to provide level support.

Center vent shipping block – place under the shipping pad to provide level support

CAUTION: GLASS IS FRAGILE.

DO NOT BUMP EDGE OF GLASS DURING INSTALLATION.

Locate the reflective tape and foam gasket tape included with your cooktop.

Smooth rough edges of the cutout. Install reflective tape to the opening, along the inside and 3/8to 1/2of the opening edge.

Place reflective tape within 1/2of cutout

Reflective tapetop and vertical sides

Peel off the white backing to install the foam gasket tape on the bottom side of the cooktop glass as shown.

Foam Gasket Installation Notes:

The foam gasket tape should be installed within 1/8of the edge of the glass. Do not stretch or twist the foam gasket tape.

CAUTION: Failure to install foam gasket tape greatly increases the potential of breaking the cooktop glass when installing, especially in Corian® or granite countertops.

Use care not to stretch the foam gasket tape while it is installed or it will not stay in place.

Do not place foam gasket tape over the metal flanges.

Butt the foam gasket tape ends together at each corner without overlapping.

Trim the foam gasket tape to length without stretching.

Mitre cut outside corners of foam gasket tape slightly if necessary for appearance.

Underside

Foam

of Glass

Gasket

 

Tape

18

max. to

Glass Edge

Do not scratch the glass while cutting the foam gasket tape.

Note: On PGP989S model, apply the foam tape around the outer edge of the glass only on the sides and rear of the unit.

24

Page 24
Image 24
GE PGP989 manual Unpacking the COOKTOP/INSTALLING the Gasket, Do not Bump Edge of Glass During Installation