Installation Instructions
CABINET PREPARATION
1PREPARING FOR INSTALLATION
Positioning the cooktop
The cooktop is designed to look best when centered in a cabinet at least 30″ wide.
The exhaust vent beneath the cooktop must be located between wall studs or floor joists so that the ductwork may be installed properly.
13″ max.
depth of
unprotected
2PREPARING THE BASE CABINET
This cooktop is designed to fit easily into a variety of cabinets. However, the combined installation of a downdraft vent and a cooktop require careful consideration.
Some cabinets may require modifications.
This installation requires a 24″ min. deep cabinet base. The cabinet must be at least 30″ wide.
Preparing a cabinet that is against a wall
In some cabinets, the sides may need to be
overhead cabinets
30″ min. clearance
from countertop to unprotected overhead surface
18″ min. height from countertop to nearest cabinet on either side of the unit
5″ min. clearance
from cutout to
side walls
scooped or cut down 53⁄4″ as shown, and the corner braces removed in order to accommodate the unit.
In 75 cm and 90 cm frameless European cabinets, the back panel may need to be cut down 53⁄4″ to accommodate the unit.
Preparing a peninsula or island-type cabinet
In a peninsula or island type cabinet, the sides may need to be scooped or cut down, and the corner braces removed in order to accommodate the unit.
53⁄4″ Approx. for European cabinets
The downdraft system with blower, motor and ductwork will occupy the cabinet below the cooktop. Drawers cannot be installed below this cooktop.
Avoid placing cabinets above the cooktop unit, if possible, in order to reduce the hazards caused by reaching over heated surface units.
If the cabinetry is used above the cooktop, allow a minimum 30″ clearance between the cooking surface and the bottom of the unprotected cabinet.
If the clearance between the cooktop and the cabinetry is less than 30″ , the cabinet bottom must be protected with a flame retardant millboard at least 1/4″ thick, or gypsum board at least 3/16″ thick, covered with 28 gauge sheet steel or 0.020″ thick copper. Clearance between the cooktop and the protected cabinetry MUST NEVER BE LESS
THAN 24 ″ .
EXCEPTION: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance.
Working areas adjacent to the cooktop should have an 18″ minimum clearance between the countertop and the bottom of the cabinet. If the clearance is less than 18″ , the adjacent cabinets should be at least 5″ from the side edge of the cooktop.
53⁄4″ Approx.
18
