GE r08654v-1 Cutout for 30″ 76.2 cm Single or Double, Built-In Ovens only - Over a Warming Drawer

Cabinetry

A

Cutout for 30″ (76.2 cm) Single or Double

Built-In Ovens only – Over a Warming Drawer

For JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960, ZET938, ZET958 models only.

Single 30″ (76.2 cm)	Double 30″ (76.2 cm)
Oven Over a Warming	Oven Over a Warming
Drawer	Drawer

Per Warming

Drawer

Requirement

Anti-Tip Block Against

Rear Wall Per Warming

Drawer Requirement

2” (5.1 cm)

Min.

NOTE: Install the oven only with specific models listed on the label located on top of the oven.

Per Warming

Drawer

Requirement

1” (2.5 cm) Min. Above Toekick or

Adjust to Oven Installation Height

Anti-Tip Block

Against Rear

Wall Per

Warming

Drawer

Requirement

2” (5.1 cm)

Min.

1” (2.5 cm) Min. Above Toekick

NOTE: Additional clearances between cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height.

•When installing a Warming Drawer below a single or double oven, a separate 120V, 60 Hz, properly grounded receptacle must be installed. Refer to installation instructions packed with the Warming Drawer for specific installation requirements.

12