GE r08654v-1 installation instructions Installation, Instructions, Before You Begin, Tools Needed

Installation	Built-In Wall Oven
	27” (68.6 cm) models
	JKS10, JKP30, JKP35, JKP55, JKP70, JKP75,
	PK916, PK956, ZEK938, ZEK958
Instructions	30” (76.2 cm) models
	JTP30, JTP35, JTP55, JTP70, JTP75, PT916,
	PT920, PT956, PT960, ZET938, ZET958

If you have questions, call 1.800.GE.CARES or visit our website at: ge.com

Before You Begin	• Proper installation is the responsibility
	of the installer and product failure due
Read these instructions carefully and completely.	to improper installation is NOT covered
• IMPORTANT—Save these	under warranty.
	• NOTE—This appliance must be properly
instructions for local inspector’s use.
	grounded.
• IMPORTANT—Observe all
	• ATTENTION INSTALLER
governing codes and ordinances.
• Note to Installer—Be sure to leave these	All electric wall ovens must be hard wired
instructions with the consumer.	(direct wired) into an approved junction
• Note to Consumer—Keep these	box. A plug and receptacle is NOT permitted
	on these products.
instructions for future reference.

Parts Included

(Appearance will vary)

Materials Needed

Wire Nuts

Screws For Installation (8-18 x .750 flat head Phillips wood screws)

WB07T10578 – Black WB07T10579 – SS Optional 27″ (68.6 cm) Metal Bottom Trim Assembly (on some models or can be purchased separately)

27″ (68.6 cm) Metal Bottom Trim

30″ (76.2 cm) Metal Bottom Trim Assembly

Strain Relief Clamp	Junction
for 1/2” conduit	Box

36” (91 cm) of String

Tools Needed

1/8” (3 mm) Drill Bit and	Phillips
Electric or Hand Drill	Screwdriver

31-10647-3 11-07 JR

1