Cutout for 27″ 68.6 cm Single Built-In Ovens only

Installation Instructions

Cutout for 27″ (68.6 cm) Single Built-In

Ovens only

For JKS10, JKP30, JKP70, PK916, ZEK938 models only.

Cabinet Width 27” (68.6 cm)

Allow 1” (2.5 cm) for overlap of oven over side edges of cutout

2” x 4”

(5 cm x 10 cm) or equivalent runners level with bottom of cutout

		5” (12.7 cm)
		Max. from the
		left or right
	Cabinet	side	Junction Box
	Width		Junction Box
	Width		Location
27”	(68.6	cm)	Location
27”	(68.6	cm)

Cutout Width 25” (63.5 cm)

Min.

25 1/4” (64.1 cm)

Max.

Cutout			22” (55.9 cm)
Height
			Min. above
27 5/8”
			base rail
(70.2 cm) Min.

28 1/8”
(71.4 cm) Max.

Recommended
Cutout Location
from Floor	32	1/2” (82.6 cm)
Cutout Depth	23	1/2”
	(59.7 cm) Min.
Cutout Width	25” (63.5 cm) Min.
	25	1/4” (64.1 cm) Max.
Cutout Height	27	5/8” (70.2 cm) Min.
	28	1/8” (71.4 cm) Max.

20” (50.8 cm)

Allow a minimum of 20” (50.8 cm) for clearance to adjacent corners, drawers, walls, etc. when door is open

				Alternate Junction
				Box Location –
				access from
				adjacent cabinet
Allow				adjacent cabinet
Allow			Recommended	may be required
1” (2.5 cm)				may be required
1” (2.5 cm)
minimum for		cutout location
overlap of		from floor 32 1/2”
oven top	and	(82.6 cm)

bottom
of cutout

NOTE: If the cabinet does not have a front frame and the sides are less than 3/4” (1.9 cm) thick, shim both sides equally to establish the cutout width.

If the cabinet does not have a solid bottom, two braces or runners must be installed level with the bottom of the cutout to support the weight of the oven. For single ovens, the runners and braces must support 150 lbs (68 Kg).

NOTE: If marks, blemishes or the cutout opening are visible above the installed oven, it may be necessary to add wood shims under the runners and front trim until the marks or opening are covered.

2” x 4” (5 cm x 10 cm) or equivalent runners level with bottom of cutout

24”

(61 cm)

18” (45.7 cm)