Installation Instructions

5REASSEMBLE DOOR ASSEMBLY

Turn the inner door over and place on a soft, protected flat surface so that

the inner part is facing down. Assemble

the chrome cover to the inner door by

placing them together.

Flip the door assembly over and assemble, using 7 screws (#10 x 1.125tapping screws).

7 x A Screws

6REVERSE FRONT PANEL PLUG BUTTONS AND STRIKE PLATE

Remove the 2 plug buttons on the dryer front panel, using a putty knife or other flat tool as shown, and reinstall on the opposite side. Switch the strike bracket and its cover by removing

2 screws (#8 x 0.625tapping screws) for each and reinstalling on opposite sides.

2Plug buttons

Protective piece of tape

Strike bracket

NOTE: Apply a protective piece of tape to the side of the plug button where the putty knife blade will be inserted to prevent scratching.

7REINSTALL DOOR ASSEMBLY

Place the door back on the dryer front panel, making sure the latch is engaged and the hinge is sitting in the two openings in the dryer front. Assemble the door to the front cabinet, using 2 screws (#10 x 0.75tapping screws).

Install 2 x B screws

Install the new left-hand hinge cap (from the reversibility kit) onto the hinge, by opening the dryer door and screwing the hinge cap into place.

NOTE: Save the remaining caps and covers in case you want to reverse the hinge again.

Hinge cap

1 x C Screw in hinge cap

39

Page 39
Image 39
GE UPVH880 Reassemble Door Assembly, Reinstall Door Assembly, Reverse Front Panel Plug Buttons and Strike Plate