GE UPVH880 Level the Washer or Dryer, Reinstall the Drawer, Remove Shipping Screws

Installation Instructions

4 LEVEL THE WASHER OR DRYER

AStand the washer or dryer upright. Move it close to its final location.

BMake sure that the washer or dryer is level by placing a level on top. Check side to side and front to back.

CUse an open

ended wrench to adjust the legs in and out. Tighten the lock nut against the bottom

of the pedestal.

NOTE: To minimize vibration, the locking nuts must be tight.

5 REINSTALL THE DRAWER

ACheck to

be sure the slides are closed.

B Slide the drawer

into the Drawer Divider

opening. Align the drawer supports to the slides on each side.

CReinstall the original screws into each drawer slide. Tighten both screws.

DOpen the drawer fully. Slide drawer divider into slots in the center of the drawer. The drawer should slide smoothly when you push it closed.

6 REMOVE SHIPPING SCREWS

Remove the 4 shipping screws on the back side of the washer.

7 FINALIZE THE INSTALLATION

Refer to the washer or dryer Installation Instructions to complete the installation.

45