GE UPVH880 Prepare the Pedestal, Install the Pedestal To the Washer or Dryer, For Dryers only

Installation Instructions

INSTALLING THE PEDESTAL (if desired) (cont.)

2 PREPARE THE PEDESTAL

APull the drawer out as far as it

will go.

BRemove screws from drawer

slides. Slide drawer out of the base and set aside.

FOR DRYERS ONLY:

CLocate the 4 support pads from the parts package. Each pad has 2 protrusions that fit into the holes on top of the pedestal. Press the rubber pads into each set of corner holes on the top of the pedestal as shown.

3INSTALL THE PEDESTAL

TO THE WASHER OR DRYER

APlace the pedestal against the bottom

of the unit. Check to be sure the drawer front is at the front of the washer.

BAlign the holes in the pedestal with the holes in the bottom of the unit. Use a Phillips screwdriver to install the 4 bolts through the pedestal and into the unit—do not tighten.

CSlide the pedestal toward the unit, until it is aligned front to back. Use a 7 mm socket wrench to securely tighten the bolts.

NOTE: The support pads should be installed on the dryer only. DO NOT INSTALL THESE PADS ON THE WASHER PEDESTAL.

44