GE ZVC30, ZVC48 ZVC42, 39-1/2″, 38-3/4″W x 13-3/16″D, Design Information, Product Dimensions

	Design Information
PRODUCT DIMENSIONS
ZVC42	Dimensions and Specifications (in inches)
	Outside Dimensions
	39-1/2″

*Opening

14″

The custom canopy must be sized to fit the insert sleeve. Construct the canopy with an opening that is:

38-3/4″W x 13-3/16″D

The opening must be constructed of 3/4″ thick material to allow the sleeve locking clips to engage.

The Supplied Liner	1/2″
7/8″	40-1/2″
7-1/2″	1/2″
4″	21-1/4″
Front side

The stainless steel liner is shipped with each hood insert . This non-combustible liner protects the underside of the canopy.

Custom Liner

If you are not using the supplied liner, you may construct a custom non-combustible liner. Use the supplied liner as a template. The opening must be 38-3/4″W x 13-3/16″D.3/4″ thick material must surround the opening to allow the sleeve locking clips to engage. The insert sleeve inside the cabinet should be positioned 1/2″ from the rear wall so that the center of the 8″ duct is 5-1/2″from the rear wall.

The Insert Sleeve

13″ 29-1/2″

	14″
Front side	1/2″
38-1/2″	13″

1/2″

A 1/2″ wide flange surrounds the outside edge of the insert sleeve.

Remote Location for the Control

The control may be removed from the hood and installed into a wall or countertop. A 30-ft . length of wire is supplied to accommodate most installations. A blanking plate covers the opening when the controls are removed.

The overall size of the control is 4-1/4″wide and 2-1/4″deep.

3-11/16″

	Control cutout
1-11/16″

We recommend that the cutout in granite or other hard surfaces be made before the countertop is installed.

7