GE ZVC30, ZVC42, ZVC48, ZVC36 Remote Mounting of the Control Wired, Remote Location for Control

Installation Preparation

REMOTE MOUNTING OF THE CONTROL – WIRED

WARNING: Disconnect electrical power from unit before beginning remote control installation. Failure to do so could result in personal injury or damage to the electrical controls.

3-11/16″

	Control cutout
1-11/16″

REMOTE LOCATION FOR CONTROL

NOTE: The hood is only certified for use with the supplied 30-ft . length of wire.

The control can be removed from the hood and installed in a backsplash or countertop.

•A cover plate is provided to cover the opening in the hood when the control is removed.

•A 30-ft . length of 4-wire cord is supplied to accommodate most installations. Because only 30-ft . of cord is provided, careful consideration must be given to the location of the remotely mounted control.

•The 30-ft . cord is supplied with a connector/ converter on one end. DO NOT REMOVE the connector/converter from the 30-ft . cord. Failure to use the connector/converter with the shorter cord will prevent proper operation of the control.

NOTE: Not for telecommunication (telephone) network.

•The cord must be routed through the holes in the insert sleeve, and the rubber grommets put into place around the cord.

NOTE: On the ZVC30 and ZVC36 models, the cord needs to be routed through the holes in the insert sleeve before the damper plate is installed.

•Route the cord through the conduit to reach the installation location of the control.

Remotely Mounted Control—Wall or Countertop Installation

	Long cord	Connector/ Short cord
Display board		converter

Main

PCB

15