RMT-4-IR Remote Installation | Gefen EXT-HDMI1.3-CAT6-4X specification

RMT-4-IR REMOTE INSTALLATION

Installing the RMT-4-IR Battery

To use the RMT-4-IR Remote, remove the battery cover on the back of the

remote to reveal the battery compartment. Insert the included battery into the open battery slot. The positive (+) side should be facing up. Ensure that both DIP switches are set to the OFF position. Replace the battery cover and the IR Remote is ready for action.

The IR Remote ships with 2 batteries. One battery is required for operation and the other battery is a spare.

Battery Slot

I/R Code DIP Switches

9

Image 12

Gefen EXT-HDMI1.3-CAT6-4X user manual RMT-4-IR Remote Installation, Installing the RMT-4-IR Battery

Contents

4x CAT6 Extender For Hdmi Asking for Assistance Technical SupportTechnical Support Hours Write To Contents Introduction GefenGefen 4x CAT6 Extender for Hdmi How It Works Operation Notes Features Supported Hdmi 1.3 FeaturesFeatures Package Includes Sender Panel Layout Sender Panel Descriptions CAT6 Output Jack Receiver Panel Layout Receiver Panel Descriptions Control Buttons IR Remote Description RMT-4-IR Remote Optional RMT-4-IR Remote Installation Installing the RMT-4-IR Battery RMT-4-IR Remote Configuration Setting the IR Remote Channel on the RMT-4-IR Connecting the 4X CAT6 Extender for Hdmi How to Connect the 4x CAT6 Extender for Hdmi Matrix Mode Connecting and Operating 4X CAT6 Extender for Hdmi Example 1 Routing Input source 3 to Output display Connecting and Operating the 4X CAT6 Extender for Hdmi Connecting and Operating the 4X CAT6 Extender for Hdmi RMT-4-IR Button Source Hdmi cable To Display CAT6 Out From Extender Connecting and Operating the 4X CAT6 Extender for Hdmi DIP Switch Configuration DIP Switch Location Matrix Mode / Stand-alone ModeDefault settings for DIP switches Receiver Unit bottom DIP 2 Deep Color DIP 3 / DIP 4 IR Remote Channel RS-232 Settings RS-232 Serial Control InterfaceBinary Table Routing Sources using RS-232 Receiver Unit Matrix Mode Use the RS-232 controller to send the following command RS-232 Serial Commands CommandFunctions Syntax Fiber Optic Extender Status F0 Command #LOCKPOWER Function #RMTIRADD Function IP Control View Matrix Status IP Configuration Backup / Restore Power Management Network Cable Wiring Diagram Pin Color Firmware Update Firmware Update Procedure Firmware Update Specifications Warranty Product Registration Licensing Page Rev C3 Nordhoff St., Chatsworth CA