Cisco Systems manual Installing Hardware Options for the WAVE-594 and WAVE-694, C H A P T E R

C H A P T E R 4

Installing Hardware Options for the WAVE-594 and WAVE-694

This chapter provides basic instructions for installing hardware options in your WAVE-594 and WAVE-694. These instructions are intended for technicians who are experienced with setting up Cisco WAVE-594 and WAVE-694 hardware.

This chapter contains the following sections:

•Installing a Cisco WAVE Interface Module, page 4-1

•Replacing a Hard Disk Drive/Solid State Drive, page 4-2

•Replacing a Fan, page 4-4

•Replacing a Power Supply, page 4-5

•Installing Memory, page 4-6

Installing a Cisco WAVE Interface Module

In addition to the two onboard Gigabit Ethernet ports, the WAVE-594 and WAVE-694 can accommodate one optional Interface Module network module:

•4-port Gigabit Ethernet Copper Bypass Interface Module

•8-port Gigabit Ethernet Copper Bypass Interface Module

•4-port Gigabit Ethernet Fiber Optic Bypass Interface Module

•2-port 10 Gigabit Ethernet Fiber Optic SPF+ Interface Module

For information on the features of the Cisco WAVE Interface Modules and cabling requirements, see Chapter 5, “WAVE Interface Modules.”

Note Interface Modules are not hot-swappable therefore it is necessary to power the system down before installing or replacing.

Caution To maintain proper system cooling, do not operate the appliance for more than 1 minute without either an Interface Module or a filler panel installed in the bay.

To install a Cisco Interface Module in the Interface Module slot, follow these steps:

Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide

OL-24619-02 4-1