Cisco Systems 694, WAVE594K9 manual Mounting in a 4-Post Rack, 1 Attaching the Brackets

Chapter 3 Installing the WAVE-594 and WAVE-694

Rack Mounting and Cabling the WAVE-594 and WAVE-694

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety:

•This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

•When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

•If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1006

Mounting in a 4-Post Rack

Follow these steps to mount the WAVE appliance in a 4-post rack:

Step 1 Prepare for installation by reading the “Rack-Mounting Considerations, Parts, and Tools” section on page 3-1) and verify that you have the correct tools and rack-mount hardware necessary for the installation.

Step 2 Attach the front rack mount brackets (item #1 in Table 3-1) using the six front bracket screws (item #4 in Table 3-1). (See Figure 3-4.)

Step 3 Attach the rear rack mount holder brackets (item #2 in Table 3-1) using the six rear bracket holder screws (item #5 in Table 3-1).

Note The front arrow must point toward the front of the chassis.

Figure 3-1 Attaching the Brackets

330144

Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide

OL-24619-02 3-3