Cisco Systems WAVE594K9, 694 manual Installing Memory, Removing the Cover

Chapter 4 Installing Hardware Options for the WAVE-594 and WAVE-694

Installing Memory

Step 3 Disengage the latch and pull the power supply out by the handle. (See Figure 4-4.)

Figure 4-4 Power Supply Assembly

246692

Step 4 Within one minute, insert the new power supply with the surface marked “TOP” facing up and verify that the latch is engaged.

Step 5 Insert the power cord into the replacement power supply.

Step 6 Check the power LED to verify that the new power supply is receiving power.

Note If a power supply alarm occurs and you power down the WAVE appliance to replace the power supply, you must use the clear bmc event-logglobal configuration command and then reboot to clear the alarm.

Installing Memory

This section provides basic instructions for installing memory in your WAVE-594 and WAVE-694. It contains the following topics:

•Removing the Cover, page 4-6

•Installing Memory Modules, page 4-7

Removing the Cover

Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.

Statement 1

Caution To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them.

Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide

4-6 OL-24619-02