Cisco Systems WAVE594K9, 694 manual Connecting Power and Booting the System, Checking the LEDs

Chapter 3 Installing the WAVE-594 and WAVE-694

Connecting Power and Booting the System

Figure 3-6		Cable Connections—Front
1	2	3	4	5

			330060
1	Console port (mini-USB)	4	10/100/1000 GE 0/1 connector
2	Console port (RJ-45)	5	External USB port
3	10/100/1000 GE 0/0 connector

Connecting Power and Booting the System

To connect power to your system, follow these steps:

Step 1 Review the information in the “Safety Guidelines” section on page 2-2.

Step 2 Plug a power cord into the power cord receptacle on the back of the WAVE appliance.

Step 3 Connect the other end of the power cord to a power source at your installation site.

Step 4 Power up all externally connected devices.

Step 5 Press the power control button on the front of the WAVE appliance.

The system should begin booting. Once the operating system boots, you are ready to initialize the basic software configuration. (See the software configuration guide for details.)

Note While the WAVE appliance is powering up, the green power-on LED on the front of the appliance is on.

Checking the LEDs

When the WAVE-594 and WAVE-694 is up and running, observe the front panel LEDs (see Figure 1-1and Table 1-1) to verify that your system is operating properly.

To troubleshoot using the LEDs, see Chapter 6, “Troubleshooting the System Hardware.”

Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide

3-8 OL-24619-02