CARRIAGE LOCK
The Carriage Lock can be manually engaged or disengaged.
•To disengage Carriage Lock
–Pull handle towards opener.
•To engage Carriage Lock
–Pull handle towards door.
UP/DOWN FORCE
1.By turning the Down Force Control CLOSE clockwise,
the DOWN force can be increased. By turning the Down Force Control CLOSE
2.Once the desired level is selected, this stores the maximum force level for the DOWN direction in memory.
OPEN
3.By turning the Up Force Control clockwise, the
UP force can be increased. By turning the Up Force
OPEN
Control
4.Once the desired level is selected, this stores the maximum force level for the UP direction in memory.
ERASE - OPEN/CLOSE TRAVEL LIMIT
1.Press and hold both of the "SET" buttons ( SET & SET ) together until the green indicator light blinks (about 5 seconds).
2.All close and open travel limit settings are erased. Then follow the steps above to reprogram close and open travel limits.
NOTE: The operator will not close the door automatically unless the Safety Beam System is installed.
CONTACT REVERSE TEST
The force adjustments and limit switch settings MUST BE COMPLETED before testing.
1.Testing.
•Open garage door using wall control.
–Place a 2" x 4" board (laid flat) under center of garage door opening (Fig.
•Close door using wall control.
•When door contacts board, it must stop and reverse (within 2 seconds) to open position.
2.Adjustment.
•If the door does not properly reverse.
–Check to see if door has "close" limit programmed. It should not have reached its "close" limit before hitting board.
–If the door STOPS but does not reverse, decrease "CLOSE FORCE" control CLOSE setting slightly (turn it
•Test again. Repeat as necessary.
DOOR |
|
UNLOCK | LOCK |
TO RELEASE | TO RECONNECT |
PULL TOWARD | PULL TOWARD |
THE OPENER | DOOR |
FIG.
Up Force
OPEN Control
Adjustment
FORCE | ROTATE |
CLOCKWISE | |
| ROTATE |
|
CLOSE Down Force
Control
Adjustment
FIG.
FIG.
20 | PN# 3642036212, 8/09/2007 |
|