Genie 1024, 1022 manual Light Bulb/Lens Installation, Battery replacement, Visor clip, Light bulb

8 REMOTE CONTROL BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION

1.Battery replacement.

•Use coin, ball-point pen or similar device.

–Gently push straight in on battery cover lock tab as shown (Fig. 8-1).

•Flip open battery cover.

–Remove old battery.

•Make sure new battery is facing proper direction (Match battery polarity with symbols inside battery cover) (Fig. 8-2).

–Recommended replacement battery type: Alkaline A23, 12 volt.

•Slip new battery into place.

–Snap battery cover shut.

•Operate remote to make sure it is working properly. (No re-programming is needed.)

2.Visor clip.

You will have to install the visor clip if you choose to carry your remote attached to the car visor.

•Slide visor clip into back of remote control.

– It will snap into place (Fig. 8-3).

9LIGHT BULB/LENS INSTALLATION

NOTE: For lens cover locate Box 4.

1.Light bulb.

•Recommendations.

–Do NOT use a short neck bulb.

–Light bulb should be no more than 60 Watts.

–Use a heavy duty service bulb for longer life.

•Screw bulb into socket.

2.Lens.

•Select the white (lamp) cover. Do NOT use the colored cover in this location.

•Line up lamp lens tabs on power head with corresponding slots in lens (Fig. 9-1).

•Slide lens onto power head. Make sure the tabs are fully engaged into lens slots (Fig. 9-2).

•Plug power cord back into electrical outlet.

Slide out

FIG. 8-1 Open battery cover.

–and + polarity marks

FIG. 8-2 Match battery polarity.

FIG. 8-3 Attach visor clip.

Light bulb

Lens tabs

FIG. 9-1 Slide lens onto motor cover.

FIG. 9-2 Fasten lens.

22 PN# 3642036212, 8/09/2007