Genie 1022, 1024 manual 3b. Wiring pre-wired, Route wire from ceiling to power head

3b. Wiring (pre-wired).

•Route wire from wall to Safety Beam sensors. (Fig. 4-5b).

•Splice pre-wiring to shortened sensor wire, match wire pairs dash-to-dashand plain-to-plain.

-Trim sensor wire to approximately one foot (1 ft) from sensor.

-Split and strip ends of sensor wires and

pre-wired wires. (Fig. 4-7)
- Splice wires together with (provided)
wire nuts.
	Wire Nut
• Route wire from ceiling to power head.
(Fig. 4-5b).
• Securely fasten wires where they exit
wall and ceiling as you go.
– Use insulated staples.
– Staples should be snug only.	Insulated
		Staple

CAUTION

Staples which are too tight can cut or pinch wires. Cut or pinched wires can cause the Safety Beam System to stop working. When using the insulated staples, make sure you fasten them only as tightly as needed to hold the wire snugly.

4.Split and strip ends of sensor wires (Fig. 4-7).

NOTE: For rear cover locate Box 4.

5.Attach Safety Beam wire to power head wire terminal.

•Route Safety Beam wires through wire guide.

–Insert wire into terminal holes and lightly press in the orange locking clips above each terminal hole. (You can use a pencil or small screwdriver to comfortably reach in and lightly press down locking clips.) Insert white wires to 'even' terminal holes and striped wires into 'odd' terminal holes (Fig. 4-8).

Locking

Clips Terminal

Holes

6 5 4 3 2 1

–Confirm wire lock by lightly tugging on the wire. The wire should remain in the terminal hole.

•Install rear cover. The rear cover is the same color as the power head clips and body

(Fig. 4-9).

•Do not install the white (lamp) cover at this time.

NOTE: Safety Beam alignment check must be performed following connection to electrical power (see page 18). DO NOT PLUG IN YET!

Wall		Wall
Red	Green
Source	Sensor
Ceiling	6 5	4 3	2 1	or	6 5	4 3	2 1
Power	Dashed Line = striped wire
Head	Solid Line = white wire

FIG. 4-5b Pre-Wired source and sensor wiring

methods.

Wire		Insert Wire
		Into Connector
		Wire
		Use this
		wire routing
		if NOT pre-wired
	Invisible Light Beam	Sensor
Sensor	Protection Area

FIG. 4-6 Wire routing.

	FIG. 4-7
2"	Splitting and stripping.
	1/2"
	6	5	4	3	2	1
FIG. 4-8					+ –
Insert wires.					P	B
	InfaredSensor

(Power Head With Rear Cover Not Shown)

Cover clips

FIG. 4-9 Install rear cover.

PN# 3642036212, 8/09/2007 17