After that, the Array List screen appears, displaying the RAID array that you have created (Figure 7). (Note: BBS stands for BIOS Boot Specification. This indicates that the boot device is defined in the BIOS.)
MediaShield BIOS Jul 27 2007
- Array List -
Boot | Status | Vendor | Array | Size |
BBS | Healthy | NVIDIA | STRIPE | 223.57G |
[KL] Select [B] Set Bootable | [N] New Array [ENTER] Detail | |||
|
| Figure 7 |
|
|
To read more information about the RAID array, press <Enter> to enter the Array Detail screen (Figure 8), which shows various information about the array, including the RAID mode, stripe block size, hard drive model name, and hard drive capacity, etc.
|
| Array 1: NVIDIA STRIPE 233.57G | |
|
| - Array Detail - |
|
RAID Mode: Striped |
|
|
|
Stripe Width : 2 |
| Stripe Block: 64K |
|
Port | Index | Disk Model | Capacity |
0.0 | 0 | ST3120026AS | 111.79GB |
0.2 | 1 | ST3120026AS | 111.79GB |
| [R] Rebuild | [D] Delete [C] Clear MBR | [ENTER] Return |
|
| Figure 8 |
|
To clear MBR, press <C> in the Array Detail screen. When the "Clear MBR?" message appears, press <Y> to clear or <N> to cancel.
To delete the array, press <D> in the Array Detail screen. When the "Delete array?" message appears, press <Y> to confirm or <N> to cancel. Press <Enter> to return to the Array List screen.
To exit the NVIDIA RAID setup utility, press <Esc> in the main menu or <Ctrl>+<X> in the Array List screen.
Now, you can proceed to the installation of the SATA controller driver and operating system.
- 77 - | Appendix |
